D-Link DGS-1510 Series Reference Manual page 293

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Command Default Level
Level: 1.
Usage Guideline
Use this command to display IGMP snooping information for all VLANs where IGMP snooping is
enabled.
Example
This example shows how to display IGMP snooping global state.
Switch#show ip igmp snooping
IGMP snooping global state: Enabled
Switch#
This example shows how to display IGMP snooping information on VLAN 2.
Switch#show ip igmp snooping vlan 2
IGMP snooping state
Minimum version
Fast leave
Report suppression
Suppression time
Querier state
Query version
Query interval
Max response time
Robustness value
Last member query interval
Proxy reporting
Switch#
33-17 show ip igmp snooping groups
This command is used to display IGMP snooping group information learned on the Switch.
show ip igmp snooping groups [vlan VLAN-ID | IP-ADDRESS]
Parameters
vlan VLAN-ID
IP-ADDRESS
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
: Disabled
: v1
: Enabled (host-based)
: Disabled
: 10 seconds
: Enabled (Non-active)
: v2
: 300 seconds
: 20 seconds
: 2
: 3 seconds
: Enabled (Source 1.2.2.2)
(Optional) Specifies the VLAN interface to be displayed. If no VLAN
is specified, IGMP snooping group information of all VLANs will be
displayed, at which IGMP Snooping is enabled.
(Optional) Specifies the group IP address to be displayed. If no IP
address is specified, all IGMP group information will be displayed.
290