D-Link DGS-1510 Series Reference Manual page 78

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
5-14 show ip telnet server
This command is used to obtain information about the Telnet server status. Use this command in any
EXEC mode or any configuration mode.
show ip telnet server
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display information about the Telnet server status.
Example
This example shows how to display information about the Telnet server status.
Switch# show ip telnet server
Server State: Enabled
Switch#
5-15 show ip http server
This command is used to obtain information about the http server status. Use this command in EXEC
mode or any configuration mode.
show ip http server
Parameters
None.
Default
By default, the state is enabled.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display information about the http server status.
Example
This example shows how to display information about the http server status.
75