D-Link DGS-1510 Series Reference Manual page 359

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Example
This example shows how to enable the advertising MAC/PHY Configuration/Status TLV.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# lldp dot3-tlv-select mac-phy-cfg
Switch(config-if)#
43-5 lldp fast-count
This command is used to configure the LLDP-MED fast start repeat count option on the Switch. Use
the no form of this command to revert to the default setting.
lldp fast-count VALUE
no lldp fast-count
Parameters
VALUE
Default
By default, this value is 4.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When an LLDP-MED Capabilities TLV is detected, the application layer will start the fast start
mechanism. This command is used to configure the fast start repeat count which indicates the
number of LLDP message transmissions for one complete fast start interval.
Example
This example shows how to configure the LLDP MED fast start repeat count.
Switch# configure terminal
Switch(config)# lldp fast-count 10
Switch(config)#
43-6 lldp hold-multiplier
This command is used to configure the hold multiplier for LLDP updates on the Switch. Use the no
form of this command to revert to the default setting.
lldp hold-multiplier VALUE
no hold-multiplier
Parameters
Specifies the LLDP-MED fast start repeat count value. This value
must be between 1 and 10.
356