D-Link DGS-1510 Series Reference Manual page 358

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# configure terminal
Switch(config)#interface eth1/0/1
Switch(config-if)#lldp dot1-tlv-select vlan-name 1-3
Switch(config-if)#
This example shows how to enable the LACP Protocol Identity TLV advertisement.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# lldp dot1-tlv-select protocol-identity lacp
Switch(config-if)#
43-4 lldp dot3-tlv-select
This command is used to specify which optional type-length-value settings (TLVs) in the IEEE 802.3
Organizationally Specific TLV set will encapsulated in the LLDPDUs and sent to neighbor devices.
Use the no form of this command to disable the transmission of the TLVs.
lldp dot3-tlv-select [mac-phy-cfg | link-aggregation | power |max-frame-size]
no lldp dot3-tlv-select [mac-phy-cfg | link-aggregation | power |max-frame-size]
Parameters
mac-phy-cfg
link-aggregation
power
max-frame-size
Default
No IEEE 802.3 Organizationally Specific TLV is selected.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command enables the advertisement
of the optional IEEE 802.3 Organizationally Specific TLVs. The respective TLV will be encapsulated in
LLDPDU and sent to other devices if the advertisement state is enabled.
(Optional) Specifies the MAC/PHY Configuration/Status TLV to
send. The MAC/PHY Configuration/Status TLV is an optional TLV
that identifies (1) the duplex and bit-rate capability of the sending
IEEE 802.3 LAN node, and (2) the current duplex and bit-rate
settings of the sending IEEE 802.3 LAN node.
(Optional) Specifies the Link Aggregation TLV to send. The Link
Aggregation TLV indicates contains the following information.
Whether the link is capable of being aggregated, whether the link is
currently in an aggregation, and the aggregated port channel ID of
the port. If the port is not aggregated, then the ID is 0.
(Optional) Specifies the power via MDI TLV to send. Three IEEE
802.3 PMD implementations (10BASE-T, 100BASE-TX and
1000BASE-T) allow power to be supplied over the link for
connected non-powered systems. The Power Via MDI TLV allows
network management to advertise and discover the MDI power
support capabilities of the sending IEEE 802.3 LAN station.
(Optional) Specifies the Maximum Frame Size TLV to send. The
Maximum Frame Size TLV indicates the maximum frame size
capability of the implemented MAC and PHY.
355