D-Link DGS-1510 Series Reference Manual page 630

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
An existing discriminator can be configured. The later setting will overwrite the previous setting.
Associate a discriminator with the logging buffered and the logging server command.
Example
This example shows how to create a discriminator named "buffer-filter" which specifies two sub-filters,
one based on the severity level and the other based on the facility.
Switch# configure terminal
Switch(config)# logging discriminator buffer-filter facility includes STP severity
includes 1-4,6
Switch(config)#
71-5 logging server
This command is used to create a SYSLOG server host to log the system messages or debug output.
Use the no form of this command to remove a SYSLOG server host.
logging server {IP-ADDRESS | IPV6-ADDRESS} [severity {SEVERITY-LEVEL | SEVERITY-
NAME}] [facility FACILITY-TYPE] [discriminator NAME] [port UDP-PORT]
no logging server {IP-ADDRESS | IPV6-ADDRESS}
Parameters
IP-ADDRESS
IPV6-ADDRESS
SEVERITY-LEVEL
SEVERITY-NAME
FACILITY-TYPE
discriminator
port UDP-PORT
Default
None.
Command Mode
Specifies the IP address of the SYSLOG server host.
Specifies the IPv6 address of the log server host.
(Optional) Specifies the severity level of system messages. The
messages at that severity level or a more severe level will be
logged to the log server. This value must be between 0 and 7. 0 is
the most severe level. If not specified, the default severity level is
warnings (4).
(Optional) Specifies the severity level of system messages by one
of the following names: emergencies, alerts, critical, errors,
warnings, notifications, informational, debugging.
(Optional) Specifies the facility type as a decimal value from 0 to 23.
If not specified, the default facility is local7 (23).
(Optional) Specifies to filter the message to the log server based on
discriminator.
(Optional) Specifies the UDP port number to be used for the
SYSLOG server. Valid values are 514 (the IANA well-known port) or
any value from 1024 to 65535. If not specified, the default UDP port
is 514.
627