D-Link DGS-1510 Series Reference Manual page 370

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
show lldp
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the LLDP system's global configurations.
Example
This example shows how to display the LLDP system's global configuration status.
Switch#show lldp
LLDP System Information
Chassis ID Subtype
Chassis ID
System Name
System Description
System Capabilities Supported: Repeater, Bridge
System Capabilities Enabled
LLDP-MED System Information:
Device Class
Hardware Revision
Firmware Revision
Software Revision
Serial Number
Manufacturer Name
Model Name
Asset ID
PoE Device Type
PoE PSE Power Source
LLDP Configurations
LLDP State
LLDP Forward State
Message TX Interval
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
43-21 show lldp interface
This command is used to display the LLDP configuration at the physical interface.
show lldp interface INTERFACE-ID [, | -]
: MAC Address
: 3C-1E-04-A1-CC-00
: Switch
: Gigabit Ethernet SmartPro Switch
: Repeater, Bridge
: Network Connectivity Device
: A1
: 1.00.012
: 1.30.003
:
: D-Link Corporation
: DGS-1510-28XMP Gigabit Ethernet
:
: PSE Device
: Primary
: Disabled
: Disabled
: 30
367