D-Link DGS-1510 Series Reference Manual page 81

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# telnet 10.90.90.91
User Access Verification
Username:
This example shows how to Telnet through port 23 to 10.90.90.91 and the connection failed. Try
using port 3500 instead to login into the management interface.
Switch#telnet 10.90.90.91
ERROR: Could not open a connection to host on server port 23.
Switch# telnet 10.90.90.91 3500
User Access Verification
Username:
5-19 terminal length
The command is used to configure the number of lines displayed on the screen. The terminal length
command will only affect the current session. The terminal length default command will set the
default value but it doesn't affect the current session. The newly created, saved session terminal
length will use the default value. Use the no form of this command to revert to the default setting.
terminal length NUMBER
no terminal length
terminal length default NUMBER
no terminal length default
Parameters
NUMBER
Default
By default, this value is 24.
Command Mode
Use the EXEC Mode or Privilege EXEC Mode for the terminal length command.
Use the Global Configuration Mode for the terminal length default command.
DGS-1510-28P Gigabit Ethernet SmartPro Switch
Command Line Interface
Firmware: Build 1.30.004
Copyright(C) 2015 D-Link Corporation. All rights reserved.
DGS-1510-28P Gigabit Ethernet SmartPro Switch
Command Line Interface
Firmware: Build 1.30.004
Copyright(C) 2015 D-Link Corporation. All rights reserved.
Specifies the number of lines to display on the screen. This value
must be between 0 and 512.When the terminal length is 0, the
display will not stop until it reaches the end of the display.
78