D-Link DGS-1510 Series Reference Manual page 707

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
bandwidth is configured less than "0" or greater than maximum supported value, the bandwidth will be
ignored.
To assign the 802.1p Default Priority by the RADIUS server, the proper parameters should be
configured on the RADIUS server. The table below shows the parameters for 802.1p default priority.
The parameters of the Vendor-Specific attributes are:
Vendor-Specific
Attribute
Vendor-ID
Vendor-Type
Attribute-Specific Field
If the user has configured the 802.1p priority attribute of the RADIUS server (for example, priority 7)
and 802.1X, MAC-based Access Control, JWAC or WAC authentication is successful, the device will
assign the 802.1p default priority (according to the RADIUS server) to the port. However, if the user
does not configure the priority attribute and authenticates successfully, the device will not assign a
priority to this port. If the priority attribute is configured on the RADIUS server is a value out of range
(>7), it will not be set to the device.
To assign the VLAN by the RADIUS server, the proper parameters should be configured on the
RADIUS server. To use VLAN assignment, RFC 3580 defines the following tunnel attributes in
RADIUS packets.
The table below shows the parameters for a VLAN:
RADIUS Tunnel Attribute
Tunnel-Type
Tunnel-Medium-Type
Tunnel-Private-Group-ID
A summary of the Tunnel-Private-Group-ID Attribute format is shown below.
0
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
The table below shows the definition of Tag field (different with RFC 2868):
Description
Defines the vendor.
Defines the attribute.
Used to assign the 802.1p
default priority of the port.
Description
This attribute indicates the
tunneling protocol(s) to be
used (in the case of a
tunnel initiator) or the
tunneling protocol in use (in
the case of a tunnel
terminator).
This attribute indicates the
transport medium being
used.
This attribute indicates
group ID for a particular
tunneled session.
1
Length | Tag
704
Value
171 (DLINK)
4
0 to 7
Value
13 (VLAN)
6 (802)
A string (VID)
2
| String...
Usage
Required
Required
Required
Usage
Required
Required
Required
3