D-Link DGS-1510 Series Reference Manual page 291

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
The ip igmp snooping static-group command allows the user to create an IGMP snooping static
group in case that the attached host does not support the IGMP protocol.
Example
This example shows how to statically add a group for IGMP snooping.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ip igmp snooping static-group 226.1.2.3 interface eth3/0/5
Switch(config-vlan)#
33-14 ip igmp snooping suppression-time
This command is used to configure the interval of suppressing duplicate IGMP reports or leaves. Use
the no form of this command to revert to the default setting.
ip igmp snooping suppression-time SECONDS
no ip igmp snooping suppression-time
Parameters
SECONDS
Default
By default, this value is 10 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. The report suppression function will
suppress the duplicate IGMP report or leave packets received in the suppression time interval. A
small suppression time will cause the duplicate IGMP packets be sent more frequently.
Example
This example shows how to configure the suppression time to be 125 on VLAN 1000.
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ip igmp snooping suppression-time 125
Switch(config-vlan)#
33-15 ip igmp snooping minimum-version
This command is used to configure the minimum version of IGMP hosts that is allowed on the
interface. Use the no form of this command to remove the restriction from the interface.
ip igmp snooping minimum-version {2 | 3}
no ip igmp snooping minimum-version
Specifies to configure the interval of suppressing duplicates IGMP
reports. The range is from 1 to 300.
288