D-Link DGS-1510 Series Reference Manual page 52

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
4-14 match ip address
This command is used to associate an IP access list for the configured sub-map. The no form of this
command removes the match entry.
match ip address {ACL-NAME | ACL-NUMBER}
no match ip address
Parameters
ACL-NAME
ACL-NUMBER
Default
None.
Command Mode
VLAN Access-map Sub-map Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to associate an IP access list with the configured sub-map. One sub-map can only
be associated with one access list (IP access list, IPv6 access list or MAC access list). IP sub-map
just checks IP packets. The newer command overwrites the previous setting.
Example
This example shows how to configure the match content in the sub-map.
Switch# configure terminal
Switch(config)# vlan access-map vlan-map 20
Switch(config-access-map)# match ip address sp1
Switch(config-access-map)#
4-15 match ipv6 address
This command is used to associate IPv6 access lists for the configured sub-maps. The no form of this
command removes the match entry.
match ipv6 address {ACL-NAME | ACL-NUMBER}
no match ipv6 address
Parameters
ACL-NAME
ACL-NUMBER
Default
None.
Specifies the name of the ACL access list to be configured. The
name can be up to 32 characters.
Specifies the number of the IP ACL access list to be configured.
Specifies the name of the IPv6 ACL access list to be configured.
The name can be up to 32 characters.
Specifies the number of the IPv6 ACL access list to be configured.
49