D-Link DGS-1510 Series Reference Manual page 579

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
This example shows how to enable sending single IP management trap.
Switch# configure terminal
Switch(config)# snmp-server enable traps sim
Switch(config)#
64-10 show sim
This command is used to display single IP management information.
show sim [{candidates [CANDIDATE-ID] | members [MEMBER-ID] | group [COMMANDER-
MAC] | neighbor}]
Parameters
candidates
CANDIDATE-ID
members
MEMBER-ID
group
COMMANDER-MAC
neighbor
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display single IP management information.
Example
This example shows how to display detailed local SIM information on the Commander.
Switch#show sim
SIM Version
Firmware Version
Management VLAN
Device Name
MAC Address
Platform
SIM State
Role State
Discovery Interval : 30 sec
Hold Time
Switch#
This example shows how to display detailed local SIM information on the Member switch.
Specifies to display the information of Candidate switches.
Specifies to display detailed information of a Candidate.
Specifies to display the information of Member switches.
Specifies to display detailed information of a Member.
Specifies to display the information of other SIM Groups.
Specifies to display detailed information of a Group.
Specifies to display the neighbor information.
: VER-1.61
: 1.30.003
: 1
: Switch
: 3C-1E-04-A1-CC-00
: DGS-1510-28XMP
: Disabled
: Candidate
: 100 sec
576