D-Link DGS-1510 Series Reference Manual page 19

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# disable
Switch# logout
2-8 end
This command is used to end the current configuration mode and return to the highest mode in the
CLI mode hierarchy which is either the User EXEC Mode or the Privileged EXEC Mode.
end
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Executing this command will return access to the highest mode in the CLI hierarchy regardless of
what configuration mode or configuration sub-mode currently located at.
Example
This example shows how to end the Interface Configuration Mode and go back to the Privileged
EXEC Mode.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)#end
Switch#
2-9 exit
This command is used to end the configuration mode and go back to the last mode. If the current
mode is the User EXEC Mode or the Privilege EXEC Mode, executing the exit command logs you out
of the current session.
exit
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
16