D-Link DGS-1510 Series Reference Manual page 245

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
None.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to associate an ERP instance with a G.8032 profile. Multiple ERP instances
can be associated with the same G.8032 profile. The instances associated with the same profile
protect the same set of VLANs, or the VLANs protected by one instance is a subset of LANs
protected by another instance.
Example
This example shows how to associate the profile "campus" with instance 1.
Switch#configure terminal
Switch(config)#ethernet ring g8032 ring1
Switch(config-erp)#instance 1
Switch(config-erp-instance)#profile campus
Switch(config-erp-instance)#
28-11 port0
This command is used to specify the first ring port of a physical ring. Use the no form of this
command to remove the settings.
port0 interface INTERFACE-ID
no port0
Parameters
INTERFACE-ID
Default
None.
Command Mode
ERP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to specify or remove the first ring port of a physical ring.
Example
This example shows how to configure the interface "eth1/0/1" as the first ring port of the G.8032 ring
"ring1".
Switch#configure terminal
Switch(config)#ethernet ring g8032 ring1
Switch(config-erp)#port0 interface eth1/0/1
Switch(config-erp)#
Specifies the interface ID of the first ring port. The interface(s) can
be a physical interface or a port-channel.
242