D-Link DGS-1510 Series Reference Manual page 514

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The configuration of this command takes effect when the scheduling mode is in the WRR mode. Use
the mls qos scheduler wrr command to change the scheduling mode to WRR mode. To satisfy the
behavior requirements of Expedited Forwarding (EF), the highest queue is always selected by the
Per-hop Behavior (PHB) EF and the schedule mode of this queue should be strict priority scheduling.
So the weight of the last queue should be zero while the Differentiate Service is supported.
Example
This example shows how to configure the queue weight of the WRR scheduling mode, queue weight
of queue 0, queue 1, queue 2, queue 3, queue 4, queue 5, queue 6, queue 7 are 1, 2, 3, 4, 5, 6, 7, 8
respectively on interface eth3/0/1.
Switch# configure terminal
Switch(config)# interface eth3/0/1
Switch(config-if)# mls qos scheduler wrr
Switch(config-if)# wrr-queue bandwidth 1 2 3 4 5 6 7 8
Switch(config-if)#
511