D-Link DGS-1510 Series Reference Manual page 494

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
BURST-MAX
conform-action
exceed-action
violate-action
ACTION
color-aware
Default
None.
Command Mode
Policy-map Class Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the police command to drop the packet or mark the packet with different quality of service (QoS)
values based on conformance level of the packet.
The combination of parameters used in this command defines the behavior of this command. The
combinations mentioned below can be used followed by their descriptions.

police KBPS exceed-action ACTION - The default burst-normal is used.

police KBPS BURST-NORMAL exceed-action ACTION - The explicit burst-normal is used.

police KBPS exceed-action ACTION violate-action ACTION - The default burst-normal and
default burst-max values are used.

police KBPS BURST-NORMAL BURST-MAX exceed-action ACTION violate-action
ACTION - The explicit burst-normal burst-max values are used.

police KBPS BURST-NORMAL exceed-action ACTION violate-action ACTION - The
explicit burst-normal values are used and the default burst-max values are used.

police KBPS BURST-NORMAL BURST-MAX exceed-action ACTION - The explicit burst-
normal values are used, but the burst-max values are not used.
Use the police KBPS command to create a single rate policer. Use the police cir command to create
a two rate policer. There are two kinds of single rate policers (1) a single rate two color policer and (2)
a single rate three color policer. If the violate action is specified in the police KBPS command, then
the policer is three colors. If not specified, the policer is two colors.
(Optional) Specifies the maximum burst size, in kilobytes.
(optional) Specifies the action to take on green color packets. If the
action is not specified, the default action is to transmit.
Specifies the action to take on yellow color packets that exceed the
rate limit.
(Optional) Specifies the action to take on red color packets. When
violate-action is not specified, the policer is a single rate two color
policer. When violate-action is specified, the policer is a single rate
three color policer.
Specifies the action to take on packets. Use one of the following
keywords:
drop - Drops the packet.
set-dscp-transmit VALUE - Sets the IP differentiated services code
point (DSCP) value and transmits the packet with the new IP DSCP
value.
set-1p-transmit - Sets the 802.1p value and transmits the packet
with the new value.
transmit - Transmits the packet. The packet is not altered.
Only one of the set-dscp-transmit and set-1p-transmit parameters
can be used when issuing this command. However, when selecting
to use both, the set-dscp-transmit and set-1p-transmit parameters,
the set-dscp-transmit parameter must be issued first followed by the
set-1p-transmit parameter.
(Optional) Specifies the option for the single rate three colors
policer. When color-aware is not specified, the policer works in the
color blind mode. When color-aware is specified, the policer works
in the color aware mode.
491