D-Link DGS-1510 Series Reference Manual page 241

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
None.
Default
None.
Command Mode
G.8032 Profile Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable or disable the propagation of the topology change notifications from
the sub-ERP instance to the major instance.
Example
This example shows how to enable the TCN propagation state for the G.8032 profile "campus".
Switch#configure terminal
Switch(config)#ethernet ring g8032 profile campus
Switch(config-g8032-ring-profile)#tcn-propagation
Switch(config-g8032-ring-profile)#
28-5 r-aps channel-vlan
This command is used to specify the APS channel VLAN for an ERP instance. Use the no form of this
command to delete the configuration.
r-aps channel-vlan VLAN-ID
no r-aps channel-vlan
Parameters
VLAN-ID
Default
None.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to assign the APS channel VLAN for an ERP instance. The APS channel
VLAN needs to be assigned before an ERP instance can be set to the operation state.
The specified APS channel VLAN does not need to exist to configure the command. But it needs to
exist before the instance can be set to the operation state.
If the APS channel VLAN is removed when the ERP instance is in operation, the ERP instance will
enter the operational disabled state.
Each ERP instances should have distinct APS channel VLAN.
Specifies the VLAN ID. The valid values are from 1 to 4094.
238