D-Link DGS-1510 Series Reference Manual page 25

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
2-16 environment temperature threshold
This command is used to configure the environment temperature thresholds. Use the no form of this
command to revert to the default setting.
environment temperature threshold unit UNIT-ID thermal THREMAL-ID [high VALUE] [low
VALUE]
no environment temperature threshold unit UNIT-ID thermal THREMAL-ID [high] [low]
Parameters
unit UNIT-ID
thermal THERMAL-ID
high
low
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the environment temperature threshold which corresponds to the
normal range of the temperature defined for the sensor. The low threshold must be smaller than the
high threshold. The configured range must fall within the operational range which corresponds to the
minimum and maximum allowed temperatures defined for the sensor. When the configured threshold
is crossed, a notification will be sent.
Example
This example shows how to configure the environment temperature thresholds for thermal sensor ID 1
on unit 1.
Switch# configure terminal
Switch(config)# environment temperature threshold unit 1 thermal 1 high 100 low 20
Switch(config)#
2-17 privilege
This command is used to configure the execution rights of a command string to a privilege level. Use
the no form of this command to revert the command string to the default setting level.
privilege MODE {level PRIVILEGE-LEVEL | reset } COMMAND-STRING
no privilege MODE COMMAND-STRING
Parameters
MODE
Specifies the unit ID.
Specifies the thermal sensor's ID.
(Optional) Specifies the high threshold of the temperature in
Celsius. The range is from -100 to 200.
(Optional) Specifies the low threshold of the temperature in Celsius.
The range is from -100 to 200. The low threshold must be smaller
than the high threshold.
Specifies the command mode of the command.
22