D-Link DGS-1510 Series Reference Manual page 233

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show ip arp inspection
Source MAC Validation
Destination MAC Validation: Disabled
IP Address Validation
VLAN State
----- -------------
10 Enabled
VLAN ACL Logging DHCP Logging
----- ----------- ----------
10 Deny
Switch#
Display Parameters
VLAN
Configuration
ACL Match
Static ACL
ACL logging
DHCP Logging
Example
This example shows how to display the trust state of interface eth3/0/3.
Switch# show ip arp inspection interfaces eth3/0/3
Interface
---------
eth3/0/3
Switch#
This example shows how to display the trust state of interfaces on the Switch.
: Disabled
: Disabled
ACL Match
------------------------------- ----------
-
Deny
The VLAN ID that enables ARP inspection.
The configuration state of ARP inspection.
Enable: ARP inspection is enabled.
Disable: ARP inspection is enabled.
The name of ARP ACL that is specified.
The configuration of the static ACL.
Yes: Static ARP ACL is configured.
No: Static ARP ACL is not configured.
The state of logging for packets dropped or permitted based on ACL
matches.
None: ACL-matched packets are not logged.
Permit: Logging when packets are permitted by the configured
ACL.
Deny: Logging when packets are dropped by the configured ACL.
All: ACL-matched packets are always logged.
The state of logging for packets dropped or permitted based on
DHCP bindings.
None: Prevent logging when packets are dropped or permitted by
the DHCP bindings.
Permit: Logging when packets are permitted by the DHCP
bindings.
Deny: Logging when packets are dropped by the DHCP bindings.
All: Logging when packets are dropped or permitted by the DHCP
bindings.
Trust State Rate(pps)
----------- ---------
untrusted 30
Burst Interval
--------------
5
230
Static ACL
-