D-Link DGS-1510 Series Reference Manual page 186

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Unsupported vlans
18-17 based-on hardware-address
This command is used to add or delete an entry of the DHCP server screen profile.
based-on hardware-address CLIENT-HARDWARE-ADDRESS
no based-on hardware-address CLIENT-HARDWARE-ADDRESS
Parameters
CLIENT-HARDWARE-
ADDRESS
Default
None.
Command Mode
Configure DHCP Server Screen Mode.
Command Default Level
Level: 12.
Usage Guideline
If a binding entry is defined with the client's MAC address, then the server message with the specified
server IP address and client address in the payload will be permitted. These binding entries restrict
that only specific servers are allowed to offer addresses to service specific clients.
If a binding entry is defined without the client's MAC address, then the server message with the
specified server IP address in the payload will be permitted. These binding entries restrict that only
specific servers are allowed to offer DHCP server services.
Example
This example shows how to configure a DHCP server screen profile named "campus-profile" which
contains a list of MAC addresses of clients.
Switch# configure terminal
Switch(config)# dhcp-server-screen profile campus-profile
switch(config-dhcp-server-screen)# based-on hardware-address 00-08-01-02-03-04
switch(config-dhcp-server-screen)# based-on hardware-address 00-08-01-03-00-01
switch(config-dhcp-server-screen)#
18-18 clear ip dhcp snooping server-screen log
This command is used to clear the server screen log buffer.
clear ip dhcp snooping server-screen log
Parameters
None.
Default
The number of the entries of which the VLAN is disabled.
(Optional) Specifies the MAC address of the client.
183