D-Link DGS-1510 Series Reference Manual page 604

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show storm-control interface eth3/0/1-2
Polling Interval
Trap
Interface
---------------------- --------------------------------------------
eth3/0/1
eth3/0/1
eth3/0/1
eth3/0/2
eth3/0/2
eth3/0/2
Total Entries: 6
Switch#
Display Parameters
Interface
Action
Threshold
Current
State
: 15 sec
: Disabled
Storm Action
Broadcast Drop
Multicast Drop
Unicast Drop
Broadcast Shutdown
Multicast Shutdown
Unicast Shutdown
The interface ID.
The configured action, the possible actions are: Drop, Shutdown,
None.
The configured threshold.
The actual traffic rate which is currently flowing though the interface.
Its unit may be percentage, kbps, PPS based on the configured
meter mode. Because hardware can only counts by PPS, this value
of this filed may be a rough value for percentage and kbps.
The current state of storm control on a given interface for a given
traffic type. The possible states are:
Forwarding: No storm event has been detected.
Dropped: A storm event has occurred and the storm traffic
exceeding the threshold is dropped.
Error Disabled: The port is disabled due to a storm.
Link Down: The port is physically linked down.
Inactive: Indicates that storm control is not enabled for the given
traffic type.
Shutdown Retries
Threshold
80/64 %
80/64 %
80/64 %
500/300 pps
500/300 pps
500/300 pps
601
: Infinite
Current State
50% Forwarding
50% Forwarding
50% Forwarding
- Error Disabled
- Error Disabled
- Error Disabled