D-Link DGS-1510 Series Reference Manual page 463

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# clear poe statistic interface eth3/0/1
Switch#
53-9 show poe power-inline
This command is used to display the Power over Ethernet (PoE) status for the specified PoE port, or
for all PoE ports in the switch system.
show poe power-inline [INTERFACE-ID [, | -]] {status | configuration | statistics |
measurement | lldp-classification}
Parameters
INTERFACE-ID
,
-
status
configuration
statistics
measurement
lldp-classification
Default
None
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the PoE status of ports, power inline configuration status, statistic
counters, the measurement result, and the data link layer classification information. If the interface ID
is not specified with this command, then all PoE interfaces will be displayed. Only the PoE capable
interfaces are displayed.
Example
This example shows how to display the PoE power inline status.
(Optional) Specifies the interface to be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and
after the hyphen.
Specifies to display the port PoE status.
Specifies to display the port configuration information.
Specifies to display the port error counters.
Specifies to display the port voltage, current, consumed power, and
temperature.
Specifies to display the data link layer classification using
information of power via MDI TLV.
460