D-Link DGS-1510 Series Reference Manual page 612

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
on
off
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command can only assure that the flow control capability has been configured in the Switch
software and not guarantee the actual hardware operation. The actual hardware operation may be
different to the settings that have been configured on the Switch because the flow control capability is
determined by both the local port/device and the device connected at the other end of the link, not just
by the local device.
If the speed is set to the forced mode, the final flow control setting will be determined by the
configured flow control setting. If the speed is set to the auto mode, the final flow control setting will be
based on the negotiated result between the local side setting and the partner side setting. The
configured flow control setting here is the local side setting.
Example
This example shows how to enable the flow control on interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# flowcontrol on
Switch(config-if)#
69-3 mdix
This command is used to configure the port Media-Dependent Interface Crossover (MDIX) state. Use
the no form of command to revert to the default setting.
mdix {auto | normal | cross}
no mdix
Parameters
auto
normal
cross
Default
By default, this option is set as auto.
Specifies to enable a port to send PAUSE frames or process
PAUSE frames from remote ports.
Specifies to disable the ability for a port to send or receive PAUSE
frames.
Specifies to set the port interface's MDIX state to the auto-MDIX
mode.
Specifies to force the port interface's MDIX state to the normal
mode.
Specifies to force the port interface's MDIX state to the cross mode.
609