D-Link DGS-1510 Series Reference Manual page 465

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show poe power-inline configuration
Interface
--------------------------------------------------------------------------------
eth3/0/1
eth3/0/2
!--- Output suppressed...
eth4/0/2
eth4/0/3
!--- Output suppressed...
eth5/0/24
eth5/0/25
Switch#
Display Parameters
Interface
Admin
Priority
Legacy-Support
Time-Range
Example
This example shows how to display the PoE power inline statistics.
Switch# show poe power-inline statistics
Interface MPS Absent
--------- ----------
eth3/0/1
eth3/0/2
!--- Output suppressed.
eth4/0/1
eth4/0/2
eth4/0/3
eth4/0/4
!--- Output suppressed.
eth5/0/24
eth5/0/25
Switch#
Display Parameters
MPS Absent
Admin Priority Legacy-Support Time-Range
auto critical enabled
auto(M) critical disabled
auto critical disabled
never high disabled
never low disabled
never low disabled
The PoE interface ID.
The user configured mode can be of the following:
Auto: The powered device will be automatically detected and
maximum power is based on the detection result.
Auto(M): The powered device will be automatically detected and
maximum power is the user configured value.
Never: The powered device will not be detected, and no power to
the port.
The priority used to prioritize the service order when power
constrain happens within at the power unit.
Enabled: The legacy PD can be detected.
Disabled: The legacy PD cannot be detected.
The time-range profile name which sets the activation time frame for
a port.
Overload
--------
2 5
2 1
2 0
2 0
2 0
2 0
2 2
2 1
Increased if the PSE stops to provide power to the PI due to the
12345678901234567890123456789012
rdtime
Short Power Denied
----- ------------
0 10
0 3
0 2
0 1
0 5
0 0
0 0
1 0
462
Invalid Signature
-----------------
7
9
3
0
1
0
0
0