D-Link DGS-1510 Series Reference Manual page 334

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
address binding table's entries. The binding table includes the dynamic table (created by IPv6
snooping) and the static table (created by the ipv6 neighbor binding vlan command)
If the policy name is not specified, the default source guard policy will permit packets sent by the auto-
configured address and deny packets sent by the link-local address.
Example
This example shows how to apply the IPv6 source guard policy "pol1" to interface eth1/0/3.
Switch# configure terminal
Switch(config)# interface eth1/0/3
Switch(config-if)# ipv6 source-guard attach-policy pol1
Switch(config-if)#
39-6 show ipv6 source-guard policy
This command is used to display the IPv6 source guard policy configuration.
show ipv6 source-guard policy [POLICY-NAME]
Parameters
POLICY-NAME
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
The command is used to display the IPv6 source guard policy configuration. If the policy name is not
specified, all IPv6 source guard polices will be display.
Example
This example shows how to display the IPv6 source guard policy configuration.
Switch# show ipv6 dhcp guard policy
Policy Test configuration:
permit link-local
deny global-autoconf
Target: eth2/0/3
Switch#
39-7 show ipv6 neighbor binding
This command is used to display the IPv6 binding table.
show ipv6 neighbor binding [vlan VLAN-ID] [interface INTERFACE-ID] [ipv6 IPV6-ADDRESS]
[mac MAC-ADDRESS]
Specifies the name of the source guard policy.
331