D-Link DGS-1510 Series Reference Manual page 83

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# terminal speed 9600
Switch(config)#
5-21 session timeout
This command is used to configure the line session timeout value. Use the no form of this command
to revert to the default setting.
session-timeout MINUTES
no session-timeout
Parameters
MINUTES
Default
By default, this value is 3 minutes.
Command Mode
Line Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This timer specifies the timeout for auto-logout sessions established by the line that is being
configured.
Example
This example shows how to configure the console session to never timeout.
Switch# configure terminal
Switch(config)# line console
Switch(config-line)# session-timeout 0
Switch(config-line)#
5-22 terminal width
The command is used to set the number of character columns on the terminal screen for the current
session line. The terminal width command will only affect the current session. The terminal width
default command will set the default value, but it doesn't affect any current sessions.
terminal width NUMBER
no terminal width
terminal width default NUMBER
no terminal width default
Parameters
NUMBER
Specifies the timeout length in minutes. 0 represents never timeout.
Specifies the number of characters to display on the screen. Valid
values are from 40 to 255.
80