D-Link DGS-1510 Series Reference Manual page 622

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# copy tftp: //10.1.1.254/switch-config.cfg running-config
Address of remote host []? 10.1.1.254
Source filename []? switch-config.cfg
Destination filename running-config? [y/n]:
Accessing tftp://10.1.1.254/switch-config.cfg...
Transmission start...
Transmission finished, file length 45421 bytes.
Executing script file switch-config.cfg ......
Executing done
Switch#
This example shows how to upload the running configuration to the TFTP server for storage.
Switch# copy running-config tftp: //10.1.1.254/switch-config.cfg
Address of remote host []? 10.1.1.254
Destination filename []? switch-config.cfg
Accessing tftp://10.1.1.254/switch-config.cfg...
Transmission start...
Transmission finished, file length 45421 bytes.
Switch#
This example shows how to save the system's running configuration into the FLASH memory and
uses it as the next boot configuration.
Switch# copy running-config startup-config
Destination filename startup-config? [y/n]:
Saving all configurations to NV-RAM.......... Done.
Switch#
This example shows how to execute the "switch-config.cfg" file in the NVRAM immediately by using
the increment method.
Switch# copy flash: switch-config.cfg running-config
Source filename [switch-config.cfg]?
Destination filename running-config? [y/n]:
Executing script file switch-config.cfg ......
Executing done
Switch#
This example shows how to download an image file from the TFTP server to all units in the stack.
y
y
y
619