D-Link DGS-1510 Series Reference Manual page 570

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
snmp-server source-interface traps INTERFACE-ID
no snmp-server source-interface traps
Parameters
INTERFACE-ID
Default
The IP address of the closest interface will be used.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to specify the interface whose IP address will be used as the source address for
sending the SNMP trap packet.
Example
This example shows how to configure VLAN 100 as the sourcing interface for sending SNMP trap
packets.
Switch# configure terminal
Switch(config)# snmp-server source-interface traps vlan 100
Switch(config)#
63-21 snmp-server user
This command is used to create an SNMP user. Use the no form of this command to remove an
SNMP user.
snmp-server user USER-NAME GROUP-NAME {v1 | v2c | v3 [encrypted] [auth {md5 | sha}
AUTH-PASSWORD [priv PRIV-PASSWORD]]} [access IP-ACL-NAME]
no snmp-server user USER-NAME GROUP-NAME {v1 | v2c | v3}
Parameters
USER-NAME
GROUP-NAME
v3
encrypted
auth
md5
sha
AUTH-PASSWORD
Specifies the interface whose IP address will be used as the source
address for sending the SNMP trap packet.
Specifies a username of a maximum of 32 characters. The syntax is
general string that does not allow spaces.
Specifies the name of the group to which the user belongs. The
syntax is general string that does not allow spaces.
Specifies that the user uses the SNMPv3 security mode.
(Optional) Specifies that the following password is in encrypted
format.
(Optional) Specifies the authentication level.
Specifies to use HMAC-MD5-96 authentication.
Specifies to use HMAC-SHA-96 authentication.
Specifies the authentication password in the plain-text form. This
567