D-Link DGS-1510 Series Reference Manual page 575

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
64-4 sim holdtime
This command is used to configure the hold-time duration in seconds. One switch (ether the
Commander or Member switch) will clear the information of the other switch, after not receiving single
IP management messages in the duration time. Use the no form to reset the hold-time to the default.
sim holdtime SECONDS
no sim holdtime
Parameters
SECONDS
Default
By default, this value is 100 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
During the hold time, If no SIM protocol message were received, it will:

For the Commander switch, clear Member switch information.

For the Member switch, clear the Commander switch information and change the role to
Candidate.
Example
This example shows how to configure the single IP management hold-time.
Switch# configure terminal
Switch(config)# sim holdtime 120
Switch(config)#
64-5 sim interval
This command is used to configure the SIM interval in seconds for single IP management protocol
sending messages. Use the no form to set the interval as default.
sim interval SECONDS
no sim interval
Parameters
SECONDS
Default
By default, this value is 30 seconds.
Command Mode
Global Configuration Mode.
Specifies the hold-time in seconds. The range is from 100 to255.
Specifies the interval value in seconds. The range is from 30 to 90.
572