D-Link DGS-1510 Series Reference Manual page 339

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
This example shows how to enable the JWAC forcible logout function.
Switch# configure terminal
Switch(config)# jwac forcible-logout
Switch(config)#
40-4 jwac max-authenticating-user
This command is used to configure the maximum authenticating user number on the specified
interface. Use the no form of this command to revert to the default setting.
jwac max-authenticating-user NUMBER
no jwac max-authenticating-user
Parameters
NUMBER
Default
By default, this value is 100.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the maximum authenticating user number for JWAC on the
specified interface.
Example
This example shows how to configure the maximum authenticating user number for JWAC to 10 on
interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# jwac max-authenticating-user 10
Switch(config-if)#
40-5 jwac authenticate-page language
This command is used to choose the authenticate page language. Use the no form of this command
to revert to the default setting.
jwac authenticate-page language {japanese | english}
no jwac authenticate-page language
Parameters
japanese
english
Specifies to set the maximum number of users being authenticated.
The range is from 1 to 100.
Specifies to choose the Japanese page.
Specifies to choose the English page.
336