D-Link DGS-1510 Series Reference Manual page 243

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
instance INSTANCE-ID
no instance INSTANCE-ID
Parameters
INSTANCE-ID
Default
None.
Command Mode
ERP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create or remove an ERP instance and enter ERP instance configuration
mode.
Example
This example shows how to create the ERP instance "1" in the physical ring named "ring2".
Switch#configure terminal
Switch(config)#ethernet ring g8032 ring2
Switch(config-erp)#instance 1
Switch(config-erp-instance)#
28-8 level
This command is used to configure ring MEL value of an ERP instance. Use the no form of this
command to revert to the default setting.
level MEL-VALUE
no level
Parameters
MEL-VALUE
Default
By default, the value is 1.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure ring MEL value of an ERP instance. The configured MEL value of
all ring nodes participate in the same ERP instance should be identical.
Example
Specifies an ERP instance number. The valid values are from 1 to
32.
Specifies the ring MEL of the specified ERP instance. The valid
values are from 0 to 7.
240