D-Link DGS-1510 Series Reference Manual page 103

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Command Default Level
Level: 15.
Usage Guideline
For accounting via the method list to take effect, enable AAA first by using the aaa new-model
command. Create the method list first by using the aaa accounting exec command. If the method list
does not exist, the command does not take effect.
Example
This example shows how to configure the EXEC accounting method list with the name of "list-1". It
uses the RADIUS server. If the security server does not response, it does not perform accounting.
After the configuration, the EXEC accounting is applied to the console.
Switch#configure terminal
Switch(config)# aaa accounting exec list-1 start-stop group radius
switch(config)# line console
switch(config-line)# accounting exec list-1
Switch(config-line)#
8-16 clear aaa counters servers
This command is used to clear the authentication and accounting (AAA) server statistic counters.
clear aaa counters servers {all | radius {IP-ADDRESS | IPV6-ADDRESS | all} | tacacs {IP-
ADDRESS | IPV6-ADDRESS | all} | sg NAME}
Parameters
all
radius IP-ADDRESS
radius IPV6-ADDRESS
radius all
tacacs IP-ADDRESS
tacacs IPV6-ADDRESS
tacacs all
sg NAME
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Specifies to clear server counter information related to all server
hosts.
Specifies to clear server counter information related to a RADIUS
IPv4 host.
Specifies to clear server counter information related to a RADIUS
IPv6 host.
Specifies to clear server counter information related to all RADIUS
hosts.
Specifies to clear server counter information related to a TACACS
IPv4 host.
Specifies to clear server counter information related to a TACACS
IPv6 host.
Specifies to clear server counter information related to all TACACS
hosts.
Specifies to clear server counter information related to all hosts in a
server group.
100