D-Link DGS-1510 Series Reference Manual page 200

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
hex HEX-STRING
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the UDF for the Remote ID.
Example
This example shows how to configure the UDF to the ASCII string "PARADISE001".
Switch# configure terminal
Switch(config)# ipv6 dhcp relay remote-id udf ascii PARADISE001
Switch(config)#
This example shows how to configure the UDF to the hexadecimal string "010c08".
Switch# configure terminal
Switch(config)# ipv6 dhcp relay remote-id udf hex 010c08
Switch(config)#
21-6 show ipv6 dhcp
This command is used to display the DHCPv6 related settings on the interface.
show ipv6 dhcp [interface [INTERFACE-ID]]
Parameters
INTERFACE-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the device's DHCPv6 DUID or use the show ipv6 dhcp interface
command to display DHCPv6 related settings and information for the specified VLAN interface. If the
interface ID is not specified, all interfaces that are enabled for the DHCPv6 function will be displayed.
Example
This example shows how to display the DHCPv6 settings for VLAN 1, which is in the DHCPv6 relay
mode.
Specifies the hexadecimal string (a maximum of 256 digits) for the
UDF of the Remote ID.
(Optional) Specifies the VLAN interface ID to display.
197