D-Link DGS-1510 Series Reference Manual page 60

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
pcp ,sctp
dscp VALUE
lt PORT
gt PORT
eq PORT
neq PORT
range MIN-PORT MAX-PORT
PROTOCOL-ID
ICMP-TYPE
ICMP-CODE
ICMP-MESSAGE
TCP-FLAG
flow-label FLOW-LABEL
fragments
time-range PROFILE-NAME
Default
None.
Command Mode
IPv6 Access-list Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If a rule entry is created without a sequence number, a sequence number will be automatically
assigned. If it is the first entry, the sequence number 10 is assigned. A subsequent rule entry will be
assigned a sequence number that is 10 greater than the largest sequence number in that access list
and is placed at the end of the list.
The user can use the command access-list sequence to change the start sequence number and
increment number for the specified access list. After the command is applied, the new rule without
(Optional) Specifies the matching traffic class value in IPv6 header.
The range is from 0 to 63, or select the following DSCP name: af11
- 001010, af12 -001100, af13 - 001110, af21 - 010010, af22 -
010100, af23 - 010110, af31 - 011010, af32 - 011100, af33 -
011110, af41 - 100010, af42 - 100100, af43 - 100110, cs1 - 001000,
cs2 - 010000, cs3 - 011000, cs4 - 100000, cs5 - 101000, cs6 -
110000, cs7 - 111000, default - 000000, ef – 101110.
(Optional) Specifies to match if less than the specified port number.
(Optional) Specifies to match if greater than the specified port
number.
(Optional) Specifies to match if equal to the specified port number.
(Optional) Specifies to match if not equal to the specified port
number.
(Optional) Specifies to match if fall within the range of ports.
(Optional) Specifies the protocol ID. The valid value is from 0 to
255.
(Optional) Specifies the ICMP message type. The valid number of
the message type is from 0 to 255.
(Optional)Specifies the ICMP message code. The valid number of
the code type is from 0 to 255.
(Optional) Specifies the ICMP message. The following pre-defined
parameters are available for selection: beyond-scope, destination-
unreachable, echo-reply, echo-request, erroneous_header, hop-
limit, multicast-listener-query, multicast-listener-done, multicast-
listener-report, nd-na, nd-ns, next-header, no-admin, no-route,
packet-too-big, parameter-option, parameter-problem, port-
unreachable, reassembly-timeout, redirect, renum-command,
renum-result, renum-seq-number, router-advertisement, router-
renumbering, router-solicitation, time-exceeded, unreachable.
(Optional) Specifies the TCP flag fields and the specified TCP
header bits called ack (acknowledge), fin (finish), psh (push), rst
(reset), syn (synchronize), or urg (urgent).
(Optional) Specifies the flow label value, within the range of 0 to
1048575.
(Optional) Specifies the packet fragment's filtering.
(Optional) Specifies the name of time period profile associated with
the access list delineating its activation period.
57