D-Link DGS-1510 Series Reference Manual page 407

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show ipv6 mld snooping
MLD snooping global state: Enabled
VLAN #1 configuration
MLD snooping state
Minimum version
Fast leave
Report suppression
Suppression time
Proxy reporting
Mrouter port learning : Enabled
Querier state
Query version
Query interval
Max response time
Robustness value
Last listener query interval
Total Entries: 1
Switch#
47-17 show ipv6 mld snooping groups
This command is used to display MLD snooping group-related information learned on the Switch.
show ipv6 mld snooping groups [IPV6-ADDRESS | vlan VLAN-ID]
Parameters
IPV6-ADDRESS
vlan VLAN-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display MLD group information by command.
Example
This example shows how to display MLD snooping group information.
: Enabled
: v2
: Enabled (host-based)
: Enabled
: 10 seconds
: Disabled (Source ::)
: Enabled (Non-active)
: v2
: 125 seconds
: 10 seconds
: 2
: 1 seconds
(Optional) Specifies the group IPv6 address. If no IPv6 address is
specified, all MLD group information will be displayed.
(Optional) Specifies the VLAN interface. If no interface is specified,
MLD group information about all interfaces will be displayed.
404