D-Link DGS-1510 Series Reference Manual page 402

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
SECONDS
Default
By default, this value is 10 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. This command configures the period
of which the group member can respond to an MLD query message before the MLD Snooping deletes
the membership.
Example
This example shows how to configure the maximum response time to 20 seconds on VLAN 1000.
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ipv6 mld snooping query-max-response-time 20
Switch(config-vlan)#
47-10 ipv6 mld snooping query-version
This command is used to configure the general query packet version sent by the MLD snooping
querier. Use the no form of this command to revert to the default setting.
ipv6 mld snooping query-version {1 | 2}
no ipv6 mld snooping query-version
Parameters
1
2
Default
By default, this version number is 2.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration.
Example
This example shows how to configure the query version to be 1 on VLAN 1000.
Specifies to set the maximum response time, in seconds, advertised
in MLD Snooping queries. The range is from 1 to 25.
Specifies that the version of the MLD general query, sent by MLD
snooping querier, is 1.
Specifies that the version of the MLD general query, sent by MLD
snooping querier, is 2.
399