D-Link DGS-1510 Series Reference Manual page 655

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Example
This example shows how to configure the VLAN name of VLAN 1000 to be "admin-vlan".
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# name admin-vlan
Switch(config-vlan)#
75-12 mac-vlan
This command is used to add the MAC-based VLAN classification entry. Use the no form of this
command to remove the MAC-based VLAN classification entry.
mac-vlan MAC-ADDRESS vlan VLAN-ID [priority COS-VALUE]
no mac-vlan MAC-ADDRESS
Parameters
MAC-ADDRESS
VLAN-ID
priority COS-VALUE
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this to add or delete the MAC based VLAN classification entry. The classification entry will be
applied to packets received by the Switch.
The user should use the switchport hybrid allowed vlan command to configure the VLAN member
port for the MAC-based VLAN.
Example
This example shows how to add a MAC-based VLAN ID entry for the MAC address 00-80-cc-00-00-
11.
Switch#configure terminal
Switch(config)#mac-vlan 00-80-cc-00-00-11 vlan 100 priority 4
Switch(config)#
75-13 protocol-vlan profile
This command is used to create a protocol group. Use the no form of this command to remove the
specified protocol group.
protocol-vlan profile PROFILE-ID frame-type {ethernet2 | snap | llc} ether-type TYPE-VALUE
no protocol-vlan profile PROFILE-ID
Specifies the MAC address for the entry.
Specifies the ID of the VLAN for the MAC-based VLAN entry.
(Optional) Specifies the priority. If not specified, the priority is 0.
652