D-Link DGS-1510 Series Reference Manual page 274

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When dynamic VLAN creation is enabled, if a port has learned a new VLAN membership and the
VLAN does not exist, the VLAN will be created automatically. Otherwise, the newly learned VLAN will
not be created.
Example
This example shows how to enable the creation of dynamic VLANs registered with the GVRP protocol.
Switch# configure terminal
Switch(config)# gvrp vlan create
Switch(config)#
31-6 gvrp forbidden
This command is used to specify a port as being a forbidden member of the specified VLAN. Use the
no form of this command to remove the port as a forbidden member of all VLANs.
gvrp forbidden {all | [add | remove] VLAN-ID [, | -]}
no gvrp forbidden
Parameters
all
add
remove
VLAN-ID [,|-]
,
-
Default
No VLANs are forbidden.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies that all VLANs, except VLAN 1, are forbidden on the
interface.
(Optional) Specifies a VLAN or a list of VLANs to be added to the
forbidden VLAN list.
(Optional) Specifies a VLAN or a list of VLANs to be removed from
the forbidden VLAN list.
(Optional) Specified the forbidden VLAN list. If the add or remove
option is not specified, the specified VLAN list will overwrite the
forbidden VLAN list. The range is 2 to 4094.
(Optional) Specifies a series of VLANs, or separate a range of
VLANs from a previous range. No spaces are required before and
after the comma.
(Optional) Specifies a range of VLANs. No spaces are required
before and after the hyphen.
271