DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
show interfaces [INTERFACE-ID [,|-]] status
Parameters
INTERFACE-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the Switch's port connection status.
Example
This example shows how to display the Switch's port connection status.
Switch# show interfaces eth1/0/1-8,3/0/1-2 status
Port
------------- ------------- ------------ ------- -------------- -------------
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
eth1/0/6
eth1/0/7
eth1/0/8
eth3/0/1
eth3/0/2
Total Entries: 10
Switch#
34-9 show interfaces utilization
This command is used to display the Switch's port utilization.
show interfaces [INTERFACE-ID [,|-]] utilization
Parameters
utilization
INTERFACE-ID
Default
(Optional) Specifies the interface ID. If no interface is specified, the
connection status of all switch ports will be displayed.
Status
VLAN
not-connected 1
not-connected 1
not-connected 1
not-connected 1
not-connected 1
not-connected 1
not-connected 1
connected
trunk
connected
2
not-connected 1
(Optional) Specifies to display the utilization information.
(Optional) Specifies the interface ID. If no interface is specified, the
utilization of all physical port interfaces will be displayed.
Duplex
Speed
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
auto
a-full
a-1000
a-full
a-1000
auto
auto
303
Type
1000BASE-T
1000BASE-T
1000BASE-T
1000BASE-T
1000BASE-T
1000BASE-T
1000BASE-T
1000BASE-T
1000BASE-T
1000BASE-T