D-Link DGS-1510 Series Reference Manual page 556

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
This example shows how to enable the SNMP server.
Switch# configure terminal
Switch(config)# snmp-server
Switch(config)#
63-5 snmp-server contact
This command is used to configure the system contact information for the device. Use the no form of
this command to remove the setting.
snmp-server contact TEXT
no snmp-server contact
Parameters
contact TEXT
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command configures the system contact information for management of the device.
Example
This example shows how to configure the system contact information with the string MIS Department
II.
Switch# configure terminal
Switch(config)# snmp-server contact MIS Department II
Switch(config)#
63-6 snmp-server enable traps
This command is used to enable the sending of trap packets globally. Use the no form of this
command to disable the sending of trap packets.
snmp-server enable traps
no snmp-server enable traps
Parameters
None.
Default
By default, this option is disabled.
Specifies a string for describing the system contact information. The
maximum length is 255 characters The syntax is a general string
that allows spaces.
553