D-Link DGS-1510 Series Reference Manual page 234

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show ip arp inspection interfaces
Interface
---------
eth3/0/1
eth3/0/2
eth3/0/3
eth3/0/5
eth3/0/6
eth3/0/7
eth3/0/8
Total Entries: 7
Switch#
Display Parameters
Interface
Trust State
Rate (pps)
Burst Interval
26-13 show ip arp inspection log
This command is used to display the ARP inspection log buffer.
show ip arp inspection log
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the content of the inspection log buffer.
Example
This example shows how to display the inspection log-buffer.
Trust State Rate(pps)
----------- ---------
untrusted 30
untrusted 30
untrusted 30
trusted None
untrusted 30
untrusted 30
untrusted 30
The name of interface that enable ARP inspection.
The state of the interface.
trusted: This interface is ARP inspection trusted port, all ARP
packet will be legal and not be authorized.
untrusted: This interface is ARP inspection untrusted port, all ARP
packet will be authorized.
The upper limit on the number of incoming packets processed per
second.
The consecutive interval in seconds over which the interface is
monitored for the high rate of the ARP packets.
Burst Interval
-------------
1
1
5
1
1
1
1
231