D-Link DGS-1510 Series Reference Manual page 203

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show interfaces transceiver detail
++ : high alarm, +
mA: milliamperes, mW: milliwatts
A: The threshold is administratively configured.
eth2/0/3
Transceiver Monitoring is enabled
Transceiver Monitoring shutdown action：Alarm
Temperature(C)
Voltage (v)
Bias Current(mA)
TX Power (mW)
RX Power (mW)
Switch#
22-2 snmp-server enable traps transceiver-monitoring
This command is used to send all or the specified level of optical transceiver monitoring SNMP
notifications. Use the no form of this command to stop sending the notifications.
snmp-server enable traps transceiver-monitoring [alarm ] [ warning]
no snmp-server enable traps transceiver-monitoring [alarm] [warning]
Parameters
alarm
warning
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to send all or the specified level of transceiver-monitoring SNMP notifications.
Example
This example shows how to start sending the SNMP notifications at the warning level.
Switch#configure terminal
Switch(config)#snmp-server enable traps transceiver-monitoring warning
Switch(config)#
: high warning, -
Current High-Alarm
30.090 75.000(A)
3.353 3.630
16.794(++) 10.500
0.258 1.413
0.000(--) 1.585
(Optional) Specifies to send or stop sending alarm level notification.
(Optional) Specifies to send or stop sending warning level
notification.
200
: low warning, -- : low alarm
High-Warning Low-Warning Low-Alarm
70.000 0.000
3.465 3.135
9.000 2.500
0.708 0.186
0.794 0.102
-5.000
2.970
2.000
0.074
0.041