D-Link DGS-1510 Series Reference Manual page 466

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Overload
Short
Power Denied
Invalid Signature
Example
This example shows how to display the PoE power inline measurement.
Switch# show poe power-inline measurement
Interface Voltage(V) Current(mA) Temperature(C) Power(W)
--------- ---------- ----------- --------------
eth3/0/1
eth3/0/2
!--- Output suppressed.
eth4/0/1
eth4/0/2
eth4/0/3
eth4/0/4
!--- Output suppressed.
eth5/0/24
eth5/0/25
Switch#
This example shows how to display the PoE power inline LLDP classification.
PSE cannot monitor the valid MPS of PD on the PI.
If the PD is drawing too much power to exceed the maximum output
power that the port can supply, then the overload counter is
increased.
If the PD's internal circuit is shorted for some reason, then this
counter is increased.
If the PoE software system decides to disallow providing power to
the attached PD, then this counter is increased.
Increased if the PSE detects a PD who has an invalid PD signature.
54.2 109
55 196
54.6 197
54.8 286
n/a n/a
n/a n/a
n/a n/a
n/a n/a
--------
35 5.9
38 10.8
32 10.7
36 15.7
n/a n/a
n/a n/a
n/a n/a
n/a n/a
463