D-Link DGS-1510 Series Reference Manual page 46

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The name must be unique among all access lists. The characters used in the name are case sensitive.
If the access list number is not specified, the biggest unused number in the range of the expert
access list numbers will be assigned automatically.
Example
This example shows how to create an extended expert ACL.
Switch# configure terminal
Switch(config)# expert access-list extended exp_acl
Switch(config-exp-nacl)# end
Switch# show access-list
Access-List-Name
-------------------------------------- ---------------
exp_acl(ID: 8999)
Total Entries: 1
Switch#
4-7 ip access-group
This command is used to specify the IP access list to be applied to an interface. Use the no form of
this command to remove an IP access list.
ip access-group {NAME | NUMBER} [in]
no ip access-group [NAME | NUMBER] [in]
Parameters
NAME
NUMBER
in
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Type
expert ext-acl
Specifies the name of the IP access list to be applied. The
maximum length is 32 characters.
Specifies the number of the IP access list to be applied.
(Optional) Specifies that the IP access list will be applied to check
packets in the ingress direction. If the direction is not specified, in is
used.
43