D-Link DGS-1510 Series Reference Manual page 561

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
no snmp-server response broadcast-request
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable or disable the server to response to broadcast SNMP GetRequest
packet. NMS tools would send broadcast SNMP GetRequest packets to discover networks device. To
support this function, the response to the broadcast get request packet needs to be enabled.
Example
This example shows how to enable the server to respond to the broadcast SNMP get request packet.
Switch# configure terminal
Switch(config)# snmp-server response broadcast-request
Switch(config)#
63-13 snmp trap link-status
This command is used to enable the notification of link-up and link-down events that occurred on the
interface. Use the no form of this command to disable the notification.
snmp trap link-status
no snmp trap link-status
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable or disable the sending of link-up and link-down traps on an interface.
Example
This example shows how to disable the generation of link-up and link-down traps on eth1/0/1.
558