D-Link DGS-1510 Series Reference Manual page 608

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to add user-defined OUI(s) for the surveillance VLAN. The OUI for surveillance
VLAN are used to identify the surveillance traffic by the surveillance VLAN function.
If the source MAC addresses of the received packet matches any of the OUI pattern, the received
packet is determined as a surveillance packet.
The user-defined OUI cannot be the same as the default OUI.
The default OUI cannot be deleted.
Example
This example shows how to add a user-defined OUI for surveillance devices.
Switch# configure terminal
Switch(config)# surveillance vlan mac-address 00-01-02-03-00-00 FF-FF-FF-FF-00-00
component-type vms description user1
Switch(config)#
68-5 surveillance vlan qos
This command is used to configure the CoS priority for the incoming surveillance VLAN traffic. Use
the no form of this command to revert to the default settings.
surveillance vlan qos COS-VALUE
no surveillance vlan qos
Parameters
COS-VALUE
Default
The default value 5.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The surveillance packets arriving at the surveillance VLAN enabled port are marked to the COS
specified by the command.
The remarking of COS allows the surveillance VLAN traffic to be distinguished from data traffic in
quality of service.
Example
This example shows how to configure the priority of the surveillance VLAN to be 7.
Specifies the priority of surveillance VLAN. The available value is
from 0 to 7.
605