D-Link DGS-1510 Series Reference Manual page 618

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Privilege EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to clear the system's configuration retained in DRAM. The configuration data will
revert to the default settings. Before using this command, save a backup of the configuration using
the copy command or upload the configuration profile to the TFTP server.
This command will clear the system's configuration settings, including IP parameters, but not the
stacking information. Thus, all the existing remote connections will be disconnected. After this
command was applied, the user needs to setup the IP address via the local console.
Example
This example shows how to clear the system's running configuration.
Switch# clear running-config
This command will clear all of system configuration as factory default setting
including IP parameters.
Clear running configuration? (y/n) [n] y
Switch#
70-4 reset system
This command is used to reset the system, clear the system's configuration, then save and reboot the
Switch.
reset system
Parameters
None.
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to clear the system's configuration, including stacking information. The
configuration data will revert to the default settings and then save it to the start-up configuration file
and then reboot switch. Before using this command, save a backup of the configuration using the
copy command or upload the configuration profile to the TFTP server.
Example
This example shows how to reset the system to the factory default settings.
615