D-Link DGS-1510 Series Reference Manual page 634

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
storage. Therefore, for this type of log messages only the first log that is generated each minute can
be stored in the system log, with the rest of them being stored in a separate table named attack log.
Example
This example shows how to display the first attack log entry.
Switch# show attack-logging index 1
Attack log messages:
1 2013-10-17 15:00:14 CRIT(2) Land attack is blocked from (IP: 10.72.24.1 Port: 7)
Switch#
71-9 clear attack-logging
This command is used to delete the attack log.
clear attack-logging {unit UNIT-ID | all}
Parameters
UNIT-ID
all
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command used to delete the attack log messages.
Example
This example shows how to delete all the attack log messages.
Switch# clear attack-logging all
Switch#
Specifies the unit on which the attack log messages will be cleared.
Specifies to clear all attack log entries.
631