D-Link DGS-1510 Series Reference Manual page 543

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
61-4 crypto pki certificate chain
This command is used to enter into the certificate chain configuration mode.
crypto pki certificate chain NAME
Parameters
NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to enter into certificate chain configuration mode. If the specified trust-point name
doesn't exist, an error message will be displayed.
Example
This example shows how to enter into certificate chain configuration mode.
Switch# configure terminal
Switch(config)# crypto pki certificate chain TP1
Switch(config-cert-chain)#
61-5 primary
This command is used to assign a specified trust-point as the primary trust-point of the Switch.
primary
no primary
Parameters
None.
Default
By default, this option is disabled.
Command Mode
CA-Trust-Point Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use the primary command to specify a given trust-point as primary. This trust-point can be used as
default trust-point when the application doesn't explicitly specify which certificate authority (CA) trust-
point should be used. Only one trust-point can be specified as the primary. The last trust-point
specified as the primary will overwrite the previous one.
Example
Specifies the name for the trust-point.
540