D-Link DGS-1510 Series Reference Manual page 84

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Default
By default, this value is 80 characters.
Command Mode
Use the EXEC Mode or Privilege EXEC Mode for the terminal width command.
Use the Global Configuration Mode for the terminal width default command.
Command Default Level
Level: 1 (for the terminal width command).
Level: 12 (for the terminal width default command).
Usage Guideline
By default, the Switch's system terminal provides a screen display width of 80 characters. The
terminal width command changes the terminal width value which applies only to the current session.
When changing the value in a session, the value applies only to that session. When the no form of
this command is used, the number of lines in the terminal display screen is reset to the default, which
is 80 characters.
The terminal width default command is available in the global configuration mode. The command
setting does not affect the current existing terminal sessions but affect the new terminal sessions that
are activated later and just the global terminal width value can be saved.
However, for remote CLI session access such as Telnet, the auto-negotiation terminal width result will
take precedence over the default setting if the negotiation is successful. Otherwise, the default
settings take effect.
Example
This example shows how to adjust the current session terminal width to 120 characters.
Switch# show terminal
Length: 24 lines
Width: 80 columns
Default Length: 24 lines
Default Width: 80 columns
Baud rate: 9600
Switch# terminal width 120
Switch# show terminal
Length: 24 lines
Width: 120 columns
Default Length: 24 lines
Default Width: 80 columns
Baud rate: 9600
Switch #
5-23 username
This command is used to create a user account. Use the no form of this command to delete the user
account.
username NAME [privilege LEVEL] [nopassword | password [0 | 7 | 15] PASSWORD]
no username [NAME]
Parameters
81