D-Link DGS-1510 Series Reference Manual page 307

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the Switch's physical port utilization.
Example
This example shows how to display the Switch's port utilization.
Switch# show interfaces utilization
Port
----------- -------------
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
eth1/0/6
eth1/0/7
eth1/0/8
Total Entries: 8
Switch#
34-10 show interfaces auto-negotiation
This command is used to display detailed auto-negotiation information of physical port interfaces.
show interfaces [INTERFACE-ID [,|-]] auto-negotiation
Parameters
auto-negotiation
INTERFACE-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the auto-negotiation information.
TX packets/sec RX packets/sec
--------------
0 0
1488109 0
0 0
0 1488109
0 0
0 0
0 0
0 0
Specifies to display detailed auto-negotiation information.
(Optional) Specifies the interface ID. If no interface is specified, the
auto-negotiation information on all physical port interfaces will be
displayed.
Utilization
-----------
0
50
0
50
0
0
0
0
304